Should be pcf7961 chip on board , remote codes at same time as transponder on 2010
if fails then
ignition on
press remote lock button
ignition off
ignition on
press remote lock button
ignition off
ignition on
press remote lock button
ignition off
ignition on
press remote lock button
locks should cycle
press remote lock button to be programmed , locks should cycle , then press lock button on additional remotes to program
ignition off to exit programming.
make sure you have correct remote.
Question:
Tried all those procedures, no luck. Maybe something wrong with the lock-mechanic, programming-modus don’t work. What about im508 or g-scan fot Asian remotes?
Answer:
Any key that can program the key can do this , but remote programs at same time as the transponder chip as pcf7961 chip on board .
so smart pro , tdb1000 , Autel im508 , Autel im608 etc etc etc . but none will program the remote on its own via diagnostics , it must be coded with transponder or by manual procedure.
have you checked fuses for central locking ? checked car is seeing ign on and off etc as if not entering programming mode then could be faulty ign switch.
are you sure vehicle has remote system fitted , alot of jazz did not have remote system fitted .
when you try the manual procedure does the car go into programming mode , do likes cycle , if yes then issue must be your remote , if no then fuse , wiring or ignition could be at fault or remote system isnt fitted.
Finally:
car cot a problem with the mechanic. Made a key without Radio.
